Electric Power System Planning

Electric Power System Planning

We have experience with a variety of system planning studies from bulk electric systems to the end consumer.

Power Flow Model Development

Our development of power flow models starts from the ground up, incorporating equipment, rating, and loading information. We then perform robust scenario analyses to ensure system stability.

Power System Reliability & Contingency Analysis

We analyze electric systems to determine how the loss of critical components affects the infrastructure.

Voltage Drop Analysis

We analyze the client’s voltage throughout its system and recommend appropriate corrections.

Short Circuit Analysis

We compare available fault current to the ratings of the equipment on the electric system.

Generation & Interconnection Studies

We analyze the effects of adding new customers, distributed generation, and interconnecting with other utilities.

Load Deliverability Analysis

We analyze load deliverability to determine whether existing systems can support additional load and offer recommendations for system support if necessary.

Engineering Economics Studies

Our net present value and cost benefit analyses ensure financial requirements are incorporated into decisions.

Construction Workplan Development

Our studies for 1 to 4-year time frames are more detailed and tailored for immediate needs.

Long-Range System Studies

We study client’s systems 10, 20, and 30 years out to determine appropriate long-term configuration.

Power Factor Correction Analysis

We optimize capacity by reducing reactive power demands.

Equipment Ratings Methodology

We develop and customize the client’s rating methodology based on standards and regional conditions to protect and optimize equipment performance.

Equipment Succession Planning

We develop equipment succession planning to ensure equipment is replaced proactively before failure rather than reactively after failure.

Spare Equipment Studies

We balance the client’s reliability needs with its inventory limitations.

Regional Working Group Representation

We attend regional working groups to provide representation for, or to collaborate with our clients.

Project Specific Cost Estimates

We operate with very little overhead and pass that savings along to our customers. Because there may be ways for us to provide additional cost savings, we prefer to provide project specific cost estimates.

Quality Customer Service

By taking the time to understand exactly what you need from us, we are able to offer remarkable service to our clients. For new clients, we strive to learn as much about the client’s drawing and engineering standards as comprehensively as we can. No project is too small - often the best way to increase our understanding of your systems us through fundamental projects.